Sunflower oil [German version]

Table of contents

General:
Product information
Packaging
Transport
  Container transport
  Cargo securing


Risk factors and loss prevention:
Temperature Odor
Humidity/Moisture Contamination
Ventilation Mechanical influences
Biotic activity Toxicity / Hazards to health
Gases Shrinkage/Shortage
Self-heating / Spontaneous combustion Insect infestation / Diseases




Product information

Product name

German Sonnenblumenöl
English Sunflower oil
French Huile de tournesol
Spanish Aceite de girasol
Scientific Helianthus annuus
CN/HS number * 1512 1 ff.


(* EU Combined Nomenclature/Harmonized System)



Product description

„Oils“ is a collective term for more or less viscous, generally organic-chemical liquids. Depending on their chemical composition, a distinction may be drawn between fatty, essential, mineral and silicone oils. Fatty oils include liquid, semisolid and solid products of vegetable and animal origin. They are also known as sweet oils.

Sunflower oil is of vegetable origin and is obtained from the fatty kernels of sunflowers. Cold-pressed crude oil is light yellow, hot-pressed crude oil has a brown color and refined oil is colorless. Sunflower oil is a high-quality edible oil. The best oil is produced from shelled kernels.

In cold conditions, substances crystallize out of wholly untreated sunflower oil which, though physiologically harmless, considerably reduce the value of the sunflower oil. These days, crystallizing substances (mainly waxes from the skin) are generally filtered out prior to transport.


Quality / Duration of storage

The acid value of an oil may be used as a measure of quality. However, the acid value of the oil must not be too high, as this denotes an excessively high content of free fatty acids, which causes the oil to turn sour. Discoloration may also occur. Sunflower oil should have an acid value of at most 0.9 – 1.1%.

Oils and fats spoil by readily becoming rancid. Rancidity is promoted by light, atmospheric oxygen and moisture and leads to changes in odor and taste. Thus, the tanks and barrels must be filled as full as possible, taking into consideration the coefficient of cubic expansion (see Density), so that as little ullage space as possible is left above the cargo. Do not load rancid oil, since it does not meet quality requirements.

Do not accept for loading sunflower oil contaminated by ferrous and rust particles or by seawater.

In cold conditions, there is a risk of substances crystallizing out of untreated sunflower oil which result in a reduction in quality.

Sunflower oil obtained from unshelled kernels is slightly cloudy, and remains so up to 40°C. This does not indicate poor quality, however.

Subject to compliance with the appropriate temperature ranges, duration of storage is not a limiting factor as regards transport and storage life.


Intended use

Sunflower oil is used as an edible oil and in margarine production.


Countries of origin

This Table shows only a selection of the most important countries of origin and should not be thought of as exhaustive.

Europe Turkey, Russia
Africa South Africa, Tanzania
Asia China
America USA, Argentina, Canada
Australia  


Back to beginning




Packaging

This oil is mainly transported in tanks, and only rarely in barrels.


Back to beginning




Transport

Symbols



Liquid cargo
Symbol, general cargo

General cargo



Means of transport

Ship, truck, railroad


Container transport

Tank containers


Cargo handling

Normally, the oil does not need to be heated, since its solidification point is relatively low. However, if temperatures should arise during the voyage which are in the solidification range, the following must be noted: to be able to pump the oil out of the tanks, it must be at the required pumping temperature. This is only possible, however, if the oil has been kept liquid during the voyage (above a minimum temperature). Loading, travel and pumping temperatures must be precisely complied with, since any change in consistency which occurs during transport may prove irreversible.

If the oil solidifies in the tanks, it cannot be liquefied again even by forced heating. In the vicinity of the heating coils, the oil melts, scorches, discolors and becomes rancid.

Pumping out may be difficult in cold weather. The oil may cool too rapidly in the long lines and solid deposits form on the outer walls, which cannot be pumped out and prevent the still liquid cargo from reaching the suction valve. This problem can be solved by appropriate heating or insulation of the lines.

Where the oil is packaged in barrels, the latter have to be handled with appropriate care. Damaged barrels quickly lead to oil leakage and thus to loss of volume or to damage to other parts of the cargo.


Density

0.918 – 0.927 cm3 [1]
0.918 – 0.926 cm3 [2]
0.917 cm3 [11]


All fats and oils have a particular density (approx. 0.9 g/cm3). With a rise in temperature, however, density diminishes, thereby leading at the same time to an increase in volume. This behavior is described by the coefficient of cubic expansion and is known as thermal dilatation.

The coefficient of cubic expansion amounts to: g = approx. 0.000746°C-1

As a rule of thumb, oils may be expected to increase in volume by 1% of their total volume for each 14°C temperature increase.

When filling the barrels or tanks, attention must however be paid to the expansion behavior of the cargo in the event of a rise in temperature (risk of bursting of barrels).


Stowage space requirements

Special tank


Segregation

Not applicable to liquid cargoes in tanks


Cargo securing

In the case of liquid cargoes, it is important for the ullage space above the cargo to be as small as possible, so that only slight movement of the cargo is possible. Movement in liquid cargoes may have a negative effect on the stability of the means of transport (e.g. during cornering in the case of trucks and trains or when ships roll and pitch).

Barrels have to be secured in such a way that they cannot slip in the hold or on the loading area and suffer damage.


Back to beginning




Risk factors and loss prevention

RF Temperature

Sunflower oil has no particular requirements as to storage climate conditions (SC 0).

The solidification temperature is of considerable significance in the transport of fatty oils and fats. They must remain liquid during loading, during the voyage and during unloading. Chill haze (separation) begins if cooling causes the temperature of the oil to approach solidification point, the oil becoming ointment-like and finally solid, such that it is no longer pumpable.

Separation and the associated change in consistency from liquid to solid occurs more readily upon cooling, the higher is the solidification point.

The oils must only be heated by a few °C per day, otherwise the risk of rancidity and other negative changes arises.

The following Table merely constitutes a rough estimate of appropriate temperature ranges. Temperatures may deviate from these values, depending on the particular transport conditions.

Designation Temperature range Source
Travel temperature

(favorable temperature range)
15°C (5 – 26°C) [1]
Solidification temperature -16 – -18°C [1]
Pumping temperature approx. 15°C  


Under normal transport conditions, sunflower oil is liquid and therefore need not be heated. It is resistant to cold, since it is free from wax, which has been previously filtered out. However, if extremely low temperatures should arise during the voyage which are in the solidification range, the oil has to be heated to prevent losses in quality and to achieve pumpability.

The travel temperature must be complied with as far as possible during transport, to minimize oxidation processes.


Back to beginning




RF Humidity/Moisture

Fats and fatty oils are insoluble in water. However, contact with water may give rise to soluble lower fatty acids and glycerol, which cause rancidity together with changes in color (yellow to brown), odor and taste as well as gelling and thickening. For this reason, the tanks must be absolutely dry after cleaning.


Back to beginning




RF Ventilation

Ventilation must not be carried out under any circumstances, as it would supply fresh oxygen to the cargo, which would promote oxidation processes and premature rancidity.


Back to beginning




RF Biotic activity

Sunflower oil displays 3rd order biotic activity.

It belongs to the class of goods in which respiration processes are suspended, but in which biochemical, microbial and other decomposition processes still proceed.

Care of the cargo during the voyage must be aimed at keeping decomposition processes to a low level.


Back to beginning




RF Gases

Before anybody enters an empty tank, it must be ventilated and a gas measurement carried out. Oxidation processes may lead to a life-threatening shortage of O2.


Back to beginning




RF Self-heating / Spontaneous combustion

The oil may ignite spontaneously in conjunction with sawdust or material residues.


Back to beginning




RF Odor

Active behavior Cold-pressed oil: pleasant odor, mild flavor

Hot-pressed oil: pungent odor and taste

Refined oil: odorless and tasteless
Passive behavior Tanks and barrels must always be odor-free, since there is a risk that quality will be diminished in particular where the previous cargo had a strong odor.



Back to beginning




RF Contamination

Active behavior Leaking oil leads to massive contamination and may make whole cargoes unusable.

Of considerable significance with regard to tank cleaning is the iodine value, which is a measure of how strong a tendency the oil has to oxidation and thus to drying. Drying is particularly detrimental to tank cleaning, as the oil/fat sticks to the walls and can be removed only with difficulty. On the basis of drying capacity, oils are divided into nondrying, semidrying and drying oils.

With an iodine value of 118 – 144, sunflower oil is a drying oil, which means that it is subject to severe drying on contact with atmospheric oxygen, so considerably complicating cleaning of the tanks. In addition, considerable weight losses sometimes occur.
Passive behavior Sunflower oil is sensitive to contamination by ferrous and rust particles and water (especially seawater).

The tanks or barrels must be clean and in a thoroughly hygienic condition before filling.



Back to beginning




RF Mechanical influences

In the case of transport in barrels, extreme mechanical stresses, such as dropping, tipping over or bumping, may lead to breakage of the barrels and thus to leakage.


Back to beginning




RF Toxicity / Hazards to health

Before anybody enters a tank, it must be ventilated and a gas measurement carried out. Oxidation processes may lead to a life-threatening shortage of O2.


Back to beginning




RF Shrinkage/Shortage

Where this oil is packaged in barrels, weight loss from leakage is always to be expected.

Sunflower oil is a drying oil. Substantial losses may therefore sometimes occur due to adhesion of the cargo to the tank walls.


Back to beginning




RF Insect infestation / Diseases

No risk.


Back to beginning